Engine Mount BRACKET SET: : 58-64 V8 If you want strong Engine

If you want strong Engine MOUNTS

then insert a suitable tool (a partially unwound paper clip works well) in the poke hole in the face to push in the plunger

Option for USA made (normally USA made) MOOG brand or good aftermarket Tie Rods

Small glass only bulb with two wire terminal as base as shown

Engine Mount BRACKET SET: : 58-64 V8 If you want strong EngineThis is the V8 Engine mount BRACKET set .. LH & RH. Your engine mount slips over this & the bolt goes thought it. Bracket head size is 2 5 8" not the smaller 2 3 8".. most 58 64's used 2. 5 8" Sold in pairs only This is whats also needed if changing from a 58 59 6cyl factory in line 6 to the chevy small block.. otherwise the tilt of the SBC will cause a rumble in the tail shaft drive line thats annoying.