Cartographer Probe v3 with ADXL345 CAN & USB Mic parts with same connector and

parts with same connector and wire length for a direct swap

This is replacement sheet suitable for most printer size and offer extra spare for smaller build size

4 (including Rev C and later)

Ender-5 S1

Cartographer Probe v3 with ADXL345 CAN & USB Mic parts with same connector andThis latest version allows for you to switch between using either CAN or USB via Firmware, no need to re solder anything. [Include both Can and USB wiring] Note board are pre flashed with CANBUS or USB Firmware depending on variant selection so you may have to re flash yourself to suit your installation if you wish to use in USB CAN mode, instructions on how to do this are available at cartographer3d documentation site https: docs. cartographer3d. com